Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Resources Infor ERP Tips & News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

Subscribe to newsletter

George Moroses
/ Categories: Infor LX & BPCS Tips

Infor LX & BPCS Tip: How to handle “ZERO COST” items

When I try to enter a 3-way match invoice with zero cost items, I get an error 'Must have value/cost entry.

Resolution
ACP500 requires a positive value to create a 'C' transaction when entering a 3-way match invoice. If you are receiving inventory items for free (no charge) and have a purchase order for it and need to include the quantity in inventory, you should first receive your items through PUR550 using something like a 'U' transaction. Then, you would enter a 'C' transaction with the quantity and zero cost through PUR550. This will change the status of the line in the HPO file to '3', fully received and costed. Once this is completed, you will be able to enter an invoice for your zero-cost item through ACP500 without getting the error message 'Must have value/cost entry.

Previous Article Infor LX & BPCS Tip: Infor LX & BPCS Cycle Counting Selection Process
Next Article Infor LN & Baan Tip: Why was the session "General Ledger Diagnostics Workbench" built?
Print
11546 Rate this article:
5.0
George Moroses

George MorosesGeorge Moroses

Other posts by George Moroses
Contact author

Theme picker

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

Understanding: The Cycle Count Transaction

If you rely on BPCS to provide you with a cycle count list, the number of items could vary from day to day from a few items to count, to several. So the person doing the cycle counting may spend a few minutes to a few hours counting items. After the cycle count is complete, the balances are not changed until the reconciliation is complete. This process could take some time before the balances are changed.

The cycle count transaction process is similar to the physical inventory transaction process.

Read more
For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
Read more
First145146147148150152153154Last

Theme picker

Tips: LN | Baan

All actions required for converting, validating, matching, and posting electronically received bank statements can be performed within a single session:

  • Bank Statement Workbench (tfcmg5610m100)
  • Bank Statement (tfcmg5610m000)

Alternatively, you can use the sequence of electronic bank statement sessions outlined below.

Steps to Process Electronic Bank Statements:

Read more
1345678910Last

Theme picker

Categories